Examples

  • Hohlraumboden

    Hohlraumboden

Floor construction

Hollow Flooring, Multiple Socket Connection Units, Floor Heating, Navifloor, Synthetic Resin Concrete, Thin Compensation D800, Thin Compensation Type S111, Vitmolit, Vitmopox, Concrete/Screeds

4-1 = The new lightweight and rapid compensations by BARiT connect the four main properties of floor construction: light weight, fast readiness, inert insulation and simple installation.

Vitmolit and Vitmopox are ideal as super fast levelling layers between wooden and brick coffered ceilings, vaulted and concrete in new ceilings in new builds and renovations.

Both levelling layers serve as subfloors in static, temporal, impact noise and thermal insulation requirements.

Quick Info

  • planar
  • low weight
  • fast readiness
  • different height compensation
  • thermal conductivity of λ = 0.19 W / mK
  • good compaction and
  • simple to use
  • recyclable

Properties

VITMOLIT consists of recyclable, lightweight granules, which are bound together with a special, quick-setting cement. Due to its material properties, Vitmolit is free of shrinkage and bonds as a levelling layer with an inert thermal insulation and compression strength of 10 N / mm 2. Structural processing is done in the same way as for standard, conventionally produced cement flooring.

Vitmolit und Vitmopox are installed with layer thicknesses from a minimum of 15 mm to a maximum of 50 mm. Thicker layers up to 350 mm can be achieved with multiply applied layers. This leveling layer is accessible after only a few hours. After twelve hours the levelling layer is set and ready for installation of ceramic coatings, textile coatings, natural stone, PVC floorings, rubber of linoleum.

Type VITMOLIT
Fields of use Remodeling new buildings
Suitability super-light and heat insulation layer
Basic raw-material inflated glas
Binding agent special cement
Application thickness ab 15 - 50 mm
Fillers/pigments Additives
Technical properties Water-mineral binding to DIN EN 13 813
Own weight less than < 700 kg/m³
Resistance to pressure DIN 1164** ca. 10 N/mm²
Heat insolation according to (Z-23-11-1154) K-Wert = 0,08 W/mk, λ = 0,19
Processing easy mixing and pumping, manual and mechanical densifying and smoothing only for permanently dry floor subconstructions
Environmental compatibility free from harmful substances and poison, full recyclability
Use Indoor
Curing at 20°C
  • ready for application
  • ready for use
 
  • after 12 hours
  • after 24 hours
** with prismamethod